Sun Joe electric pressure washer won't turn on?
Work through this troubleshooting checklist in order to identify common causes of no-power issues.
These issues may involve the GFCI plug, electrical outlet, extension cord, or the trigger and power-switch sequence.
This guide applies to corded Sun Joe electric pressure washers.
Safety First
Never touch the plug, power cord, or electrical outlet with wet hands.
Keep electrical connections dry and off the ground.
Do not use the pressure washer if the power cord, plug, or GFCI is damaged.
Troubleshooting Checklist
If your Sun Joe electric pressure washer is not turning on, follow these steps in order.
-
Reset the GFCI
Locate the GFCI on the pressure washer's power plug.
Press the RESET button until the power indicator lights up.
For additional instructions, see Using and Resetting the GFCI on a Sun Joe Electric Pressure Washer.
-
Test the Electrical Outlet
Check whether the electrical outlet is providing power.
You can test the outlet by plugging in a lamp or another suitable device.
Also check your home's circuit breaker and reset any tripped wall GFCI outlet.
-
Check the Extension Cord
If you are using an extension cord, make sure it is rated for outdoor use and meets the cord-gauge requirements listed in your model's operator's manual.
If possible, connect the pressure washer directly to the electrical outlet to determine whether the extension cord is causing the issue.
-
Connect the Water Supply First
Connect the garden hose to the pressure washer and turn the water supply on fully.
Squeeze the spray gun trigger to release trapped air before switching on the motor.
Many models may not operate properly without adequate water flow.
-
Turn On the Power Switch and Squeeze the Trigger
Turn the pressure washer's power switch to the ON position.
Release the trigger safety lock, then squeeze the spray gun trigger.
On many Sun Joe electric pressure washers, the motor operates only when the trigger is squeezed.
-
Allow the Motor to Cool
If the pressure washer stopped during operation, the motor may have overheated.
Turn the unit off, unplug it from the electrical outlet, and allow it to cool for at least 30 minutes.
After cooling, reconnect the unit and follow the proper starting sequence again.
When to Stop Troubleshooting
Stop using the pressure washer and contact Shop Joe Customer Support if any of the following occurs:
- The GFCI will not reset or continues to trip.
- The power cord, plug, or GFCI housing appears damaged.
- The motor hums but does not run.
- You notice a burning smell during operation.
- The pressure washer still has no power after completing the troubleshooting steps above.
Important Safety Reminder
If the GFCI repeatedly trips, the electrical components appear damaged, or the unit produces a burning smell, stop using the pressure washer.
Do not attempt to open or repair internal electrical components.
Other Pressure Washer Issues
Leaking or Experiencing Low Pressure Instead?
If your pressure washer powers on but you notice water leaking around the garden hose connection, see Why Is My Pressure Washer Leaking Where the Garden Hose Connects? for additional troubleshooting guidance.
Need More Help?
Still having trouble turning on your Sun Joe electric pressure washer? Contact Shop Joe Customer Support for further assistance.
Please have your complete product model number, a description of the issue, and your order number (if available) ready.